Waist-to-Hip Ratio Calculator
Where you carry fat matters as much as how much you carry. Waist-to-hip ratio (WHR) compares the fat around your middle with the fat around your hips — and fat around the waist is the kind most strongly linked to heart disease and type 2 diabetes.
Measure your waist and hip, enter them below, and see your ratio against the World Health Organization cutoffs — 0.90 for men and 0.85 for women.
Your waist-to-hip ratio
How It Works
The formula is a single division: waist-to-hip ratio = waist circumference ÷ hip circumference, with both measurements in the same units. Because the units cancel out, the ratio is the same whether you measure in centimetres or inches.
The World Health Organization defines a single cutoff for each sex, from its Expert Consultation on Waist Circumference and Waist-Hip Ratio (2008, published 2011):
| Sex | WHO cutoff | Meaning at or above the cutoff |
|---|---|---|
| Men | 0.90 | Substantially increased risk of metabolic complications |
| Women | 0.85 | Substantially increased risk of metabolic complications |
That binary verdict — at or above the cutoff, or below it — is all the WHO defines. Many consumer charts add intermediate bands such as “moderate risk”, but those bands are not WHO guidance, so this page does not show them. Note also that the WHO observed the cutoffs may need to be lower for Asian populations, where metabolic risk rises at smaller waist sizes; research on population-specific cutoffs is ongoing.
How to Measure (WHO Instructions)
Measure standing, over light clothing or bare skin, with a flexible tape held snug but not compressing the skin, after breathing out normally:
- Waist: at the midpoint between the lowest rib and the top of the iliac crest (hip bone). Find the midpoint with your fingers, mark it, and measure around at that level.
- Hip: at the widest part of the buttocks, with your feet together and your weight evenly spread.
Worked Example
Man, waist 36 in, hip 40 in: 36 ÷ 40 = 0.90 — exactly at the WHO cutoff for men, so the assessment is substantially increased risk of metabolic complications. Woman, waist 30 in, hip 38 in: 30 ÷ 38 = 0.79 — below the 0.85 cutoff for women, so lower risk by the WHO definition.
Assumptions
- Adults only. The WHO cutoffs were set for adults. They do not apply to children or teenagers, whose body proportions change as they grow.
- Measurement error matters. A tape pulled too tight, measured over thick clothing, or placed at the navel instead of the WHO midpoint can shift the ratio by several hundredths — enough to cross a cutoff. Measure twice and average.
- One measure among many. WHR captures fat distribution, not total fat. It works best alongside BMI, waist circumference itself, blood pressure and blood tests — not alone.
Sources: World Health Organization, “Waist Circumference and Waist-Hip Ratio: Report of a WHO Expert Consultation”, Geneva, 8–11 December 2008 (published 2011). Last reviewed: 15 November 2026.
Built and tested by SumKitTool — see how we check our numbers.
How to Use This Calculator
Measure yourself with a tape, enter the two numbers, and the result updates live as you type.
- Choose your sex — the WHO cutoff is 0.90 for men and 0.85 for women.
- Enter your waist and hip in centimetres or inches, measured the WHO way (see above).
- Read your ratio and the WHO verdict — at or above the cutoff, or below it.
The Reset button restores the worked example (man, waist 36 in, hip 40 in).
Tips and Practical Advice
- Measure at the same time of day. Your waist is a little larger after meals, so morning measurements before breakfast are the most consistent.
- Do not suck in. Breathe out normally and let the tape rest on the skin. Sucking in only fools the calculator.
- Track the trend. A falling ratio over months — waist shrinking faster than hips — is a good sign even if you are still above the cutoff.
- Pair it with BMI. The BMI Calculator shows total weight status while WHR shows distribution; together they give a fuller picture than either alone. The waist-to-height ratio is the sibling measure — it compares your waist with your height instead of your hips, with a single 0.5 cutoff.
Frequently Asked Questions
How is waist-to-hip ratio calculated?
Divide your waist circumference by your hip circumference, both measured in the same units: WHR equals waist divided by hip. A waist of 36 inches and hips of 40 inches gives 36 divided by 40, which is 0.90. Because the units cancel out, the answer is identical whether you measure in centimetres or inches.
What is a healthy waist-to-hip ratio?
The World Health Organization defines one cutoff per sex: below 0.90 for men and below 0.85 for women means lower risk of metabolic complications, while at or above those values means substantially increased risk. The WHO does not define intermediate risk bands, so this page gives only that binary verdict. Cutoffs may be lower for Asian populations, where metabolic risk rises at smaller waist sizes.
How do I measure my waist and hip correctly?
Follow the WHO method: stand, breathe out normally, and use a flexible tape held snug but not tight. Measure your waist at the midpoint between your lowest rib and the top of your hip bone, and your hip at the widest part of your buttocks. Measure twice and take the average, and measure in the morning before breakfast for the most consistent results.
Is waist-to-hip ratio better than BMI?
It answers a different question. BMI measures total weight for your height but cannot tell muscle from fat or say where fat sits. Waist-to-hip ratio measures fat distribution, and fat around the waist is more closely linked to heart disease and type 2 diabetes than fat elsewhere. The two work best together: BMI for overall weight status, WHR for where the fat is.
Last updated: